• The MACRObotics lab is equipped with a Form 3+ stereolithography (SLA) printer
• A good summary of the features and specifications of the Form 3+ printer can be found here

• The printer's resin tank contains a thin and very delicate film through which laser light is projected and upon which, layers of resin are cured
• Never use sharp tools to attempt to remove debris from the resin tank, doing so may pierce the film and result in resin pouring directly into the Light Processing Unit
• It is critical to carefully inspect the resin tank both before and after each and every print since debris, such as partially cured or support materials, can be dragged along the film by the mixer arm
• To inspect the tank;

- Ordered List Itemgently remove it from the printing bay (it is recommended to wear gloves to avoid getting resin on your hands),